Land Cruiser 300

Technical identity summary

Source variant count: 1 · Status: CURRENT

This page does not treat the same sales name as one vehicle across all years and markets. Rows below remain separated by source region and variant identity.

Land Cruiser 300 · Japan

Where should diagnosis start?

• Compare common-rail pressure, air path, EGR/DPF/SCR and turbo control under the same load condition.
• For AWD/4x4 variants, verify transfer/differential, tire circumference and torque distribution control separately.

Exact OEM torque, pressure, capacity, pin or calibration values are not inferred from this normalized identity record; a verified service source is required for the exact vehicle application.

System architecture: what does this record indicate?

• Fuel path is separated into low-side supply → high-pressure pump → rail → injectors; air path into MAF/MAP → turbo control → intake manifold.
• On torque-converter automatics, TCC slip, input/output speeds, commanded/actual ratio, fluid temperature and line-pressure control are tracked separately.
• In AWD/4x4, tire circumference, transfer/differential, wheel speeds and torque-distribution request are kept as separate mechanical/electronic evidence.

Freeze-frame and live-data package

• Freeze frame: first/last fault time, RPM, load, vehicle speed, system voltage, core temperatures and companion DTCs.
• Live data: rail target/actual, low-side supply where supported, MAF/MAP, boost target/actual, EGR command/feedback.
• Aftertreatment: DPF differential pressure, soot/ash calculations, EGT chain, NOx in/out and SCR/DEF dosing enable.
• Driveline: input/output speeds, commanded/actual ratio, clutch/TCC slip, fluid temperature, actuator/solenoid command and adaptations.
• Chassis/traction: four wheel speeds, steering angle, yaw/acceleration and AWD torque request/feedback on the same time base.

Measurement sequence

1. 1) Match vehicle/generation/market/powertrain/driveline identity to the source record; family name alone is not fitment evidence.
2. 2) Preserve freeze frame and companion DTCs before clearing; make the first-fault condition reproducible.
3. 3) Verify power/ground and network communication under load; do not decide from key-on static measurement alone.
4. 4) Compare commanded air/fuel/pressure with an independent physical result; separate sensor bias from real performance loss.
5. 5) Compare electronic command → hydraulic/actuator response → mechanical slip/ratio result at the same temperature and load.
6. 6) After repair, recreate the same load/temperature and verify DTC state, live-data deviation and user symptom together.

Root-cause discrimination matrix

• If rail pressure is low, separate low-side supply from high-pressure generation: when physical low-side supply is healthy but rail cannot follow target, regulation/pump/injector-leakage branches gain weight.
• For low boost, do not jump to turbo replacement: separate MAF/MAP plausibility, charge leak, VGT/wastegate command and exhaust backpressure at the same load point.
• On torque-converter automatics, separate TCC slip from actual gear-ratio error; temperature-dependent line-pressure/solenoid behavior can mimic mechanical clutch faults.
• For AWD binding/warning complaints, exclude tire-circumference or wheel-speed mismatch before condemning transfer/differential hardware.

Connected technical centers

Engine Atlas · Transmission Atlas · DTC Academy · Recall

Market and generation variants

Land Cruiser 300 · Japan · 2021–